Skip to content
Error Code

Bosch Dryer E08 / E09 / E24 / E25 / E28 / E90 Error Code

Source: Bosch US Owner Support - Dryer Error Codes

Error code E08 / E09 / E24 / E25 / E28 / E90
Appliance Dryer
Quick answer

Six dryer codes, one meaning: a fault in the electronics. Bosch lists them as technician-only repairs.

E08 / E09 / E24 / E25 / E28 / E90 needs a technician on site

E08 / E09 / E24 / E25 / E28 / E90 points to drum temperature ntc defective — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

Six different numbers can appear here: E08, E09, E24, E25, E28 and E90. Bosch gives every one of them the same description, a fault with the dryer’s electronics, and the same instruction. On its US page they share a single entry that says the fault can only be eliminated by a technician. That is why they are covered together on one page.

At a glance

Code E08 / E09 / E24 / E25 / E28 / E90
Appliance Dryer
What it means Bosch lists dryer codes E08, E09, E24, E25, E28 and E90 as electronics faults that only a technician can eliminate.
When to call a technician Bosch lists them as technician-only repairs.

One meaning, six numbers

Code Bosch description Owner fix listed?
E08 Electronics fault No
E09 Electronics fault No
E24 Electronics fault No
E25 Electronics fault No
E28 Electronics fault No
E90 Electronics fault No

Bosch does not explain why the electronics report different numbers, so the exact number does not change what you should do. Still write it down. It is the first thing a technician will ask for.

What “the electronics” covers

A modern dryer is run by its control electronics: the circuit boards that read the buttons and sensors, run the motor and heater, and show messages on the display. When the dryer reports a fault in that system, the problem sits behind the panels, not in the drum or the filter.

Before you book

  1. Note which code is showing and what the dryer was doing.
  2. Try Bosch’s general power cycle once: unplug the dryer or turn off its breaker, leave it at least five minutes, then restore power.
  3. If the code returns, stop there. Do not open the dryer to look at boards; that is mains-voltage work.

Do not confuse with

  • E06: on the same technician-only list, but for the heating circuit
  • E36: also technician-only, with no further detail from Bosch

Electronics service for Bosch dryers in San Francisco

Call (415) 851-9513 with the exact code from the display and the dryer’s model number. If the code changed after a reset, give us both numbers.

Plain language

What this code means

Bosch lists dryer codes E08, E09, E24, E25, E28 and E90 as electronics faults that only a technician can eliminate.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair