Source: Bosch US Owner Support - Dryer Error Codes
E63 is a heating element problem. Unplug, look for damage or burns on the element, and check its connections.
The heating element is the part Bosch connects with E63. It is the electric heater that warms the air blown through the drum. With a fault there, the dryer cannot produce the heat it needs, and it reports E63 instead.
At a glance
| Code | E63 |
|---|---|
| Appliance | Dryer |
| What it means | E63 on a Bosch dryer indicates a heating element problem; Bosch says to inspect the element and its connections. |
Safety first: every check below is done with the dryer unplugged. An electric dryer’s heater circuit carries household mains power, and the element itself can stay hot for a while after a cycle.
Bosch’s two owner checks
| Check | What you are looking for |
|---|---|
| Inspect the heating element | Visible damage or burn marks |
| Inspect the element’s connections | Terminals and wires that are secure, not loose |
Both checks are visual. Reaching the element usually means opening the cabinet; Bosch’s reset notes say the high-limit thermostat beside it is reached by removing the rear access panel. If you are not experienced with appliance repair, skip straight to booking service.
The red button near the element
Bosch notes that many models have a red reset button on the high-limit thermostat behind the rear panel. The high-limit thermostat shuts off heat when the dryer gets too hot. Reaching it means opening the cabinet near the heater, so leave it to a technician. If this button has tripped, it is worth asking why. A blocked vent that caused overheating is covered under E12.
Nothing visibly wrong?
Bosch’s wording is that if no visible issues are found, you may need support from a technician. A heater can fail in ways you cannot see, and checking it properly takes electrical testing. Run Bosch’s power-cycle reset first (unplugged or breaker off for at least five minutes). If E63 returns, contact service.
Other heat-related codes
- E06: heating-circuit fault that Bosch says only a technician can clear
- E12: the dryer is overheating, possibly from restricted airflow
- E56: the moisture sensor, a separate part from the heater
Heating element repair for Bosch dryers, San Francisco
Book an E63 visit at (415) 851-9513. Have the model number, and tell us whether you saw burn marks or loose wires.