Source: Bosch US Owner Support - Dryer Error Codes
Bosch gives one remedy for E04: leave about a hand's width of space above the clothes in the drum.
E04 is one of the shortest entries on Bosch’s dryer code list. Bosch does not spell out what the dryer has detected. It gives one remedy only: make sure there is enough space above the clothes in the drum, about a hand’s width.
At a glance
| Code | E04 |
|---|---|
| Appliance | Dryer |
| What it means | Bosch lists dryer E04 without stating a cause; its remedy is to leave about a hand's width of space above the clothes. |
Reading Bosch’s remedy
Because the advice is about free space, the practical question is how full the drum is. Bosch does not say why, but laundry needs room to fall and turn as the drum rotates, so that warm air can move through it. A drum packed to the top leaves no gap.
Here is how to apply Bosch’s guidance:
- Open the door and push the load down lightly. If the clothes reach the top of the drum, take some out.
- Check that you can fit a flat hand, about a hand’s width, between the top of the load and the drum.
- Close the door and restart the cycle.
- Dry the removed items as a second, smaller load.
If E04 shows with a light load
Bosch’s page does not give further steps for E04. If the code appears even with plenty of space above the laundry, try Bosch’s general power-cycle reset: unplug the dryer or turn off its breaker, wait at least five minutes, and reconnect. If that does not clear it, book a technician rather than guessing at parts.
Related dryer entries
- E03: water cannot drain because the hose is kinked
- E56: the moisture sensor, which reads the laundry as it tumbles
Bosch dryer technician in San Francisco for repair
For an E04 that stays with a half-full drum, call (415) 851-9513. Say how full the drum was and whether the power reset changed anything.