Skip to content
Error Code

Bosch Washer E:00-18 Error Code

Source: Bosch US Owner Support - Washer Error Codes

Error code E:00-18
Appliance Washer
Quick answer

The drain pump is obstructed. Clean the drain hose and pipe, then do pump maintenance as the manual describes.

Newer Bosch washer displays show drain-pump trouble as E:00-18. Bosch’s meaning is short: the pump is blocked (obstructed). Water stays in the drum because something is stopping the pump from moving it out.

At a glance

Code E:00-18
Appliance Washer
What it means The drain pump is blocked (obstructed).

Is it the pump or the building drain?

Bosch’s WAT28400UC manual gives a useful test. A washer pump that needs cleaning is one you cannot hear pumping when the washer should be draining, while other drains nearby, such as a sink, are emptying normally. If the sink is slow too, the problem may be in the household plumbing rather than the washer.

What usually ends up in the pump

According to the manual, loose debris left in the drum is the main culprit, and fabrics that shed a lot of fluff can also clog it. That is why Bosch suggests checking the drum and taking out anything visible after each load.

Bosch’s order of work

Step What to do
1 Clean the washer drain hose and/or the drain pipe it empties into.
2 If the code remains, carry out pump maintenance as your owner’s manual describes, to clear the blockage.

Pump maintenance, briefly

On the WAT28400UC the pump sits behind a service cover. Before opening it, try a Drain program once, shut the water tap, switch the washer off and unplug it. The manual warns that up to 5.3 gallons (20 liters) may need draining through the small emergency hose, so have a container ready. Unscrew the pump cover, remove what is inside, check the impeller turns, and screw the cover back tight with the handle vertical. Other models may differ, so follow the manual for yours.

Bosch’s own caution applies throughout: take care when draining hot water during pump maintenance.

Similar drain codes

  • E:36-25 / E:38-25: pump blocked, shown in another code family, with a full step-by-step.
  • E18 / F18: the older display’s drain fault, including hose and siphon cleaning.
  • E:30-80 / E:36-10: also covers a drain hose that is kinked or mounted too high.

Bosch drain pump service, San Francisco

Pump clean and E:00-18 still on the display? Call (415) 851-9513 and let us know what you found in the pump housing, if anything.

Plain language

What this code means

The drain pump is blocked (obstructed).

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair