Skip to content
Error Code

Bosch Washer E:30-80 / E:36-10 Error Code

Source: Bosch US Owner Support - Washer Error Codes

Error code E:30-80 / E:36-10
Appliance Washer
Quick answer

The washer cannot drain. Check the hose height and route, the pump and its cap, and the detergent dose.

Bosch gives E:30-80 and E:36-10 the same seven possible causes and the same fixes, word for word, so this page covers both. Every cause has to do with water leaving the machine, and most can be checked without tools.

At a glance

Code E:30-80 / E:36-10
Appliance Washer
What it means The washer cannot drain because the drain pipe or hose is blocked, kinked or mounted too high, an unsuitable hose extension is fitted, the drain pump is blocked, the pump cap is loose, or too much detergent was used.

If the washer stopped mid-program, the water inside may be hot. Switch it off, unplug it and let it cool before you open the pump.

The seven causes and what Bosch says to do

Cause Bosch’s fix
Drain pipe or outlet hose blocked Clean the drain pipe and the outlet hose.
Drain pipe or outlet hose kinked Straighten them so nothing is kinked.
Outlet hose connected too high Install it no higher than 39 in. (1 m).
Unsuitable extension on the outlet hose Remove the extension.
Drain pump blocked Clean the drain pump, using your owner’s manual.
Pump cap not assembled correctly or not fully screwed in Screw it in all the way. The handle must end up vertical.
Detergent dosage too high Pour 1 tbsp fabric softener in about 2 cups (0.5 L) of water into compartment II, then use less detergent next time.

Leave out the fabric softener mixture if the load is outdoor clothing, sportswear or anything down-filled. Bosch excludes those.

The hose height rule, explained

Bosch’s WAT28400UC installation section sets the height difference between the floor and the drain point at a maximum of 39 in. (100 cm). Bosch lists a hose connected higher than that as one cause of this code. The same manual says not to reuse an old drain hose, not to kink or modify the one supplied, and to use only the drain hose and parts included with the washer. That is why an improvised extension is on Bosch’s list of causes.

Standpipe hookups

For a standpipe, the manual has you fit the supplied elbow about 4 in. from the end of the hose, insert that section into the drain pipe, and secure it with a nylon tie strap so the hose cannot pop out during draining. A hose that has slipped out of the standpipe is worth checking while you are behind the machine.

About the pump cap handle

A loose cap is easy to miss because the service cover hides it. Bosch’s rule is simple: screw the cap in all the way, and the handle must end up vertical. If it sits at an angle after the last pump cleaning, the cap is not fully home, and that alone is on Bosch’s list for E:30-80.

After the checks

Run a Drain program. If water leaves normally, you are done. If the hose and pump are clear, the cap is tight and vertical, and the code still appears, the washer needs a technician.

Other drain codes

  • E:36-25 / E:38-25: drain pump blocked, with detailed pump-cleaning steps.
  • E18 / F18 / E:18: older-format drain fault with hose and siphon steps.
  • E:30-20: the overdosing remedy also applies to this code.

Help with Bosch washer drain repair in SF

If the drain code persists after all seven checks, call (415) 851-9513. Tell us how the drain hose is connected (standpipe or sink) and how high the drain point is.

Plain language

What this code means

The washer cannot drain because the drain pipe or hose is blocked, kinked or mounted too high, an unsuitable hose extension is fitted, the drain pump is blocked, the pump cap is loose, or too much detergent was used.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair