Skip to content
Error Code

Bosch Washer E:93 Error Code

Source: Bosch WAT28400UC Use and Care Manual, Installation Instructions (Washer), doc 9001002399_H

Error code E:93
Appliance Washer
Quick answer

The washer did not get hot water on its first cycle. Check the hot tap, hose, pressure and strainer.

E:93 appears in the error table of Bosch’s WAT28400UC Use and Care Manual for washers connected to both hot and cold water. It means the washer ran a cycle without receiving hot water.

At a glance

Code E:93
Appliance Washer
What it means Hot water is not connected or not available; on hot-water appliances the code appears at the end of the first cycle without hot water.

When E:93 shows, and when it doesn’t

The timing is unusual, and the manual spells it out:

  • It is displayed at the end of the first cycle run without hot water.
  • It is not shown again on later cycles, even if hot water is still missing.
  • It resets after a second cycle with hot water.

So a washer that showed E:93 once and then went quiet has not necessarily fixed itself. It has simply stopped reporting.

Four things to check

Possible cause Manual’s measure
Hot water tap not turned on Turn it on.
Hot supply hose kinked or pinched closed Remove the kink; replace the hose if damaged.
Hot water pressure too low Eliminate the cause.
Strainer in the supply hose clogged Clean the strainers in the supply hose; on hot-water appliances, connect both hot and cold hoses.

The hoses are color-coded in the manual: red for hot, blue for cold. A swap at installation is worth ruling out. Strainer cleaning steps are in the same manual’s maintenance section.

A hot-water safety note from the manual

If the home’s hot water system has gone unused for two weeks or more, the manual warns that hydrogen gas, which is explosive, can build up in it. Before using the washer, run every hot faucet for several minutes to release it, with no smoking or open flame nearby. That is worth knowing if E:93 appeared after a long absence.

Related supply codes

  • H9E with tap icon: Bosch’s support-page code for the same hot-supply causes.
  • E:92-01: low pressure or blocked inlet filters, with full strainer-cleaning steps.
  • E19 / F19: the washer’s own heating took too long, a different fault from missing hot water.

Bosch washer hookup and service in SF

If the hot side checks out and E:93 returns, call (415) 851-9513. The E-Nr. and FD numbers are on the rating plate inside the door or on the back of the washer.

Plain language

What this code means

Hot water is not connected or not available; on hot-water appliances the code appears at the end of the first cycle without hot water.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair