Source: Bosch US Owner Support - Washer Error Codes
The washer stopped because the door did not lock. Close it until it clicks and check for laundry caught at the edge.
When a Bosch washer shows E16, E34, F16 or F34, the program has stopped because the door is not locked properly. Bosch gives all four numbers the same meaning, so the checks below apply whichever one your display uses.
At a glance
| Code | E16 / F16 / E34 / F34 |
|---|---|
| Appliance | Washer |
| What it means | The washer door is not locked properly. |
| First thing to try | Close it until you hear the click. Bosch notes that a full load in particular can keep the door from closing properly. Push the laundry back into the drum, away from the opening, then close the door with a firm press. |
Why a front-loader needs a locked door
A front-loading washer holds water against the door glass and spins the drum at speed, so it will not run a program until the door is shut and locked. If the lock cannot engage, the cycle halts and the code appears. Bosch points to two everyday reasons: the door was not pushed closed firmly enough, or something is caught between the door and the housing.
Three checks Bosch lists
- Close it until you hear the click. Bosch notes that a full load in particular can keep the door from closing properly. Push the laundry back into the drum, away from the opening, then close the door with a firm press.
- Look along the door edge. A sleeve, sock or towel corner trapped between the door and the housing stops the door from seating. The Use and Care Manual for the WAT28400UC gives the same advice for a cycle that will not start while Start/Pause flashes.
- Restart the program. Once the door clicks shut and nothing is trapped, start the cycle again.
A door that won’t lock vs. a door that won’t open
The opposite complaint, a door that stays shut, has different causes in Bosch’s manual: an active child lock, a cycle still running, or water inside the drum that is too high or too hot. E16 and E34 are about the lock failing to engage at the start, not the door refusing to release at the end.
If the click test does not clear it
Bosch’s owner-level advice stops at closing the door, clearing the edge and restarting. If the code returns after all three, have a technician check it. It is part of a mains-powered machine, so leave the panels on and unplug the washer if it keeps faulting.
Codes people mix up with this one
- E32 / F32: the other load-related stop, triggered when laundry is unevenly distributed at spin.
- E17 / F17 / F29: the washer cannot take in enough water (blocked filters or low pressure).
Bosch washer door service in San Francisco
If E16 or E34 survives the click test, call (415) 851-9513. Have the code and the model number (E-Nr.) from the rating plate inside the door or on the back of the washer, and mention whether a full load was in the drum when it stopped.