Skip to content
Error Code

Bosch Washer E32 / F32 / E:32 Error Code

Source: Bosch US Owner Support - Washer Error Codes

Error code E32 / F32 / E:32
Appliance Washer
Quick answer

The load was unbalanced, so the washer cut or skipped the spin. Mix large and small items and run an extra spin.

Wet towels, a clump of sheets, a single bath mat: E32, F32 or E:32 on a Bosch washer is about how the laundry sat in the drum when it tried to spin. Bosch’s support page says an imbalance was detected. The WAT28400UC manual goes further and calls E:32 not a fault: the unbalanced-load detection simply interrupted the spin because the laundry was unevenly distributed.

At a glance

Code E32 / F32 / E:32
Appliance Washer
What it means An unbalanced load was detected, so the spin cycle was skipped or run at reduced speed to protect the washer.

What the washer did before showing the code

Bosch says the machine makes several spin attempts to spread the laundry, which lengthens the program, and if the imbalance is too large it lowers the spin speed or skips the spin to protect the appliance. On the WAT28400UC, E:32 then alternates with END on the display once the program has finished.

Getting the laundry spun now

  1. Open the door and spread the items evenly around the drum, mixing small and large pieces.
  2. Start an additional spin program, as the manual suggests if the clothes are still wet.

Loading habits that prevent it

  • Mix sizes. Bosch’s main advice is to wash large and small items together.
  • Close zippers and buttons on pillows and duvet covers, so other laundry cannot bunch up inside them.
  • Don’t spin one item alone. The manual lists a load that is too small as a reason no spin took place. Its fix is to add more laundry.
  • Expect fewer tries on wool. In the Wool program the manual says spin is attempted only twice, to prevent felting, so an uneven wool load is more likely to end up unspun.

Is it safe to keep using the washer?

Yes, as far as Bosch is concerned. The manual’s wording is “not a fault”. The washer reduced or skipped the spin to protect itself, which is the system doing its job. The only downside is wet laundry and a longer program.

When it is more than loading

If E32 shows up on every load, even on well-mixed ones, mention it when you book service. For a washer that shakes or shudders as spin speed rises, the manual says to check that it is level with all four feet pressing evenly on the floor, and that the transport bolts were removed. A repeat code with good loads deserves a look in person.

Other balance and spin codes

  • E:60-2B / H:32: the same unbalanced-load stop in another display format.
  • E33 / F33: excess foam, the other common reason a cycle runs long and ends wet.

Bosch washer spin problems: SF service

If E32 appears on every load, call (415) 851-9513. Have the model number from the rating plate ready and tell us what the loads contained.

Plain language

What this code means

An unbalanced load was detected, so the spin cycle was skipped or run at reduced speed to protect the washer.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair