Source: Bosch US Owner Support - Washer Error Codes
A fault in the drive circuit. Bosch says only a technician can clear it.
E80 is one of the few Bosch washer codes where Bosch gives owners no checklist at all. Its support page says there is a fault in the drive circuit and that the fault can only be eliminated by a technician.
At a glance
| Code | E80 |
|---|---|
| Appliance | Washer |
| What it means | There is a fault in the drive circuit, which only a technician can eliminate. |
| When to call a technician | Bosch says only a technician can clear it. |
What “drive circuit” covers
The drive is what turns the drum: the motor and the electronics that power and control it. Bosch does not break E80 down into specific causes, and we won’t list any.
Is there anything to try?
No. Bosch publishes no owner step for E80, not even a reset. What you can do safely:
- Turn the program selector to off and unplug the washer if it is behaving oddly, making unusual noises, or you smell burning.
- Wait for the drum to stop completely before reaching in. A turning drum can injure hands.
- If the load is still in a full drum, leave the door shut until the water has been drained properly. Hot water can scald.
Motor and control electronics run on mains voltage. Even if you are handy, this code is a reason to stop and book a visit.
What to tell the technician
A short note saves time: the code exactly as shown, which program was running, whether the drum moved at all before the stop, and whether the code came up once or repeatedly.
Other codes with no owner fix
- E20 / F20: Bosch gives no cause there either, only a reset.
- E:60-2B / H:32: if the spin stopped because the load was uneven, this is the code you would see instead.
E80 repair for Bosch washers in San Francisco
Call (415) 851-9513 to book a visit for E80. Have the model number ready and keep the washer unplugged until then.