Skip to content
Error Code

Bosch Washer E33 / F33 Error Code

Source: Bosch US Owner Support - Washer Error Codes

Error code E33 / F33
Appliance Washer
Quick answer

The washer detected too much foam. Use less detergent, especially on lightly soiled loads.

Foam spilling out of the detergent drawer is often the first thing people notice. The display then shows E33 or F33. Bosch’s explanation: the washer has detected detergent foam because too much detergent, or an old detergent, went into the load.

At a glance

Code E33 / F33
Appliance Washer
What it means Detergent foam was detected because too much detergent or an old detergent was used.

Why a light load can foam over

Bosch points out that this tends to happen with lightly soiled laundry. In that case the foam can push back out through the detergent compartment. It is a dosing issue, not a broken part.

Fixing the dose

  • Use less detergent from the next load on. Bosch is specific that slightly soiled laundry needs a reduced amount.
  • Read the dosing table on the detergent package. Bosch refers you there for quantities.
  • Replace detergent that has been sitting around for a long time, since old detergent is one of the two causes Bosch names.
  • Use HE detergent only. The WAT28400UC manual ties excess suds to non-HE detergent as well as to overdosing.

Calming the foam already in the drum

The WAT28400UC manual gives an immediate fix for excess suds. Mix 1 tablespoon of fabric softener with half a liter (1 pint) of water and pour it into the detergent compartment. The manual says to skip this with waterproof fabrics.

E33 questions

Is E33 a fault I need to report?
Bosch frames it as a detergent problem with a detergent fix. Repair is not part of its advice.

The foam is gone but the laundry is still wet.
The manual lists excessive suds as one reason no spin took place.

Related detergent and drain codes

  • E:30-20: overdosing can also trigger this newer-format code.
  • E18 / E:18: drain fault where too much or non-HE detergent is one listed cause.
  • E:30-80 / E:36-10: drain code that lists high detergent dosage among its causes.

Need a Bosch washer looked at in San Francisco?

If foam warnings continue even with a reduced HE dose, call (415) 851-9513. Tell us the detergent brand and how much you use per load.

Plain language

What this code means

Detergent foam was detected because too much detergent or an old detergent was used.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair