Skip to content
Error Code

Bosch Washer E25 / F25 Error Code

Source: Bosch Home (Egypt) Washing machine error pages E16-F28

Error code E25 / F25
Appliance Washer
Quick answer

The sensor that reads how cloudy the water is has failed. A power reset is the only owner step.

E25 / F25 needs a technician on site

E25 / F25 points to turbidity sensor fault — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

Bosch’s washing machine error list gives E25 and F25 one meaning: the turbidity sensor is faulty. This is a sensor fault, not a blockage or a loading mistake, so there is little an owner can clean or adjust.

At a glance

Code E25 / F25
Appliance Washer
What it means The turbidity sensor is faulty.

What a turbidity sensor does

“Turbidity” means cloudiness. The sensor sits in the water path and reads how murky the wash water is. Washers with this feature use that reading to judge how dirty the load is and how much rinsing it needs. When the control decides the sensor’s signal makes no sense, it reports E25. Nothing about the wash water you can see from outside tells you whether the sensor is at fault.

Is it safe to keep washing?

Bosch does not say. Its error page names the faulty sensor and nothing further: no list of causes and no owner checks. We would rather leave that question to a technician than guess.

One thing to try

Since E25 has no entry on Bosch’s US washer page, the routine Bosch gives for unlisted codes applies. Turn the washer off and on. If E25 returns, pull the plug for at least 30 seconds and plug it back in. If the code still comes back, Bosch’s advice is to book a technician with the exact message. Beyond that, the sensor is inside the machine on the water side of a mains-powered appliance and is not an owner repair.

Neighboring sensor codes

  • E26 / F26: a different sensor, the analogue pressure sensor, failing.
  • E28 / F28: flow sensor faulty, another sensor-only code with no owner fix.

Turbidity sensor service in San Francisco

If E25 is still there after the 30-second power-down, call (415) 851-9513. Have the washer’s model number handy and say whether the code appears at the same stage every time.

Plain language

What this code means

The turbidity sensor is faulty.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair