Skip to content
Error Code

Bosch Washer E26 / F26 Error Code

Source: Bosch Home (Egypt) Washing machine error pages E16-F28

Error code E26 / F26
Appliance Washer
Quick answer

The analogue pressure sensor that reads the water level has failed. Try a power reset, then call for service.

E26 / F26 needs a technician on site

E26 / F26 points to analog pressure-sensor fault — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

On a Bosch washer, E26 or F26 stands for a faulty analogue pressure sensor. That sensor is how the machine knows how much water is in the drum.

At a glance

Code E26 / F26
Appliance Washer
What it means The analogue pressure sensor is faulty.

Pressure sensor = water level sensor

As water rises in the tub, it pushes on a small column of air, and the pressure sensor turns that pressure into a level reading. Bosch’s WAT28400UC manual describes the water level sensor’s role plainly: it makes sure the water level is correct for the laundry and the program selected. An “analogue” sensor reports a continuous value rather than a simple full or empty switch.

What Bosch tells owners

For E26 Bosch’s error list gives the meaning and nothing else. No causes, no cleaning step. The US owner-support page does not list E26 at all, and for such codes it says:

  1. Turn the washer off and back on.
  2. If the message repeats, disconnect it from power for 30 seconds or more, then reconnect.
  3. If it appears yet again, book a technician and give the exact code.

Signs to note, not fix

You can observe without opening anything: whether water stands in the drum after the stop, and whether the washer filled at all. Pass that on. If there is water inside after a hot program, let it cool before any draining. Replacing a pressure sensor means working inside the cabinet, which is a job for a technician with the washer unplugged.

Codes in the same family

  • F27 / E27: Bosch lists this one separately as “pressure sensor faulty”, easy to mix up with E26.
  • E:30-10: newer-format code where one listed cause is a defective water level measurement system.
  • E28 / F28: the flow sensor, which measures incoming water instead of the level.

Have E26 looked at in San Francisco

When the power reset does not hold, call (415) 851-9513. The model number is on the rating plate inside the door or on the back of the washer. Mention whether water was left in the drum.

Plain language

What this code means

The analogue pressure sensor is faulty.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair