Skip to content
Error Code

Bosch Washer E28 / F28 Error Code

Source: Bosch Home (Egypt) Washing machine error pages E16-F28

Error code E28 / F28
Appliance Washer
Quick answer

The flow sensor that measures incoming water has failed. A power reset is worth one try before service.

E28 / F28 needs a technician on site

E28 / F28 points to flow-sensor fault — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

If your Bosch washer reads E28 or F28, Bosch’s error list says the flow sensor is faulty. This is the last entry in Bosch’s E16 to F28 washer series, and like several of its neighbors it names a part rather than a user mistake.

At a glance

Code E28 / F28
Appliance Washer
What it means The flow sensor is faulty.

Flow sensor in plain terms

A flow sensor, sometimes called a flow meter, sits in the water inlet path and counts how much water passes through as the washer fills. The control uses that count to dose the right amount of water for the load. E28 means the control no longer trusts the sensor’s signal.

Sensor fault or supply problem?

Code What Bosch says is wrong
E28 / F28 The flow sensor itself is faulty
E17 / F17 / F29 Inlet filters blocked or water pressure too low

The difference matters. A blocked filter is an owner fix. A failed sensor is not. If you see E28, the code is pointing at the part, not at your tap.

The reset worth one try

Bosch publishes no owner steps for E28. Its US page, which does not list this code, says that for unlisted codes you should switch the washer off and on, then, if needed, unplug it for at least 30 seconds. A fault that was a one-off will be gone. If E28 comes back, contact service and quote the code exactly. The sensor is inside the cabinet, so keep the panels on.

Codes worth comparing

  • E17 / F17 / F29: the supply-side code to rule out first, with filter cleaning steps.
  • E26 / F26: a sensor fault on the water-level side.

San Francisco service for a Bosch flow sensor code

Call (415) 851-9513 if E28 returns after unplugging. Give us the model number and the stage of the cycle where it stopped.

Plain language

What this code means

The flow sensor is faulty.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair