Skip to content
Error Code

Bosch Washer E:92-01 Error Code

Source: Bosch US Owner Support - Washer Error Codes

Error code E:92-01
Appliance Washer
Quick answer

Low water pressure or blocked inlet filters. Clean the strainers; if pressure itself is low, the washer cannot fix it.

E:92-01 on a Bosch washer has two possible causes: the water pressure is low, or the filters in the water inlet are blocked. Bosch’s owner-support page makes a clear distinction. No remedy is possible on the washer if the pressure itself is too low, but blocked filters you can clean.

At a glance

Code E:92-01
Appliance Washer
What it means The water pressure is low or the filters in the water inlet are blocked.
First thing to try Turn off the water tap.

Take the pressure off the hose first

Household pressure will push water out when you unscrew a supply hose. Bosch’s WAT28400UC manual suggests relieving it first:

  1. Turn off the water tap.
  2. Set the cycle selector to any wash cycle (not Drain or Spin).
  3. Touch Start/Pause and let 30 seconds pass.
  4. Turn the selector to Off.

Strainers at both ends

Tap end: unscrew the hose from the tap, rinse the strainer under running water, look for leftover debris, rinse again if needed, then reconnect.

Washer end: remove the hose from the inlet on the back of the washer, grip the strainer with narrow pliers and pull it out, rinse it, and reconnect the hose. Turn the tap on and start a warm wash to confirm water flows.

Afterward, make sure the rubber washers are seated at both ends and the connections are tight, so nothing drips.

If the pressure is the problem

When the strainers are clean and E:92-01 keeps returning, the supply is the likely limit. That is a plumbing matter, not a washer repair. Bosch’s support page for related filling faults recommends contacting a plumber about low pressure.

Preventing a repeat

The manual recommends cleaning the inlet strainers every six months anyway, especially in hard-water areas, to reduce the chance of the valve becoming blocked. It also says that if the washer’s water supply slows or stops completely, the water inlet strainer may be blocked.

Related inlet codes

  • E17 / F17 / F29: the same cause on older displays, plus Bosch’s flow-rate test for the tap.
  • E:30-10: filling fault that adds a closed faucet, kinked hose and level-system causes.
  • H9E with tap icon: the hot-water side of the same kind of supply problem.

San Francisco help for Bosch washer water supply codes

If clean strainers do not clear E:92-01 and your other faucets run strong, call (415) 851-9513. Tell us the strainers have been cleaned.

Plain language

What this code means

The water pressure is low or the filters in the water inlet are blocked.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair