Skip to content
Error Code

Bosch Cooktop F1 Error Code

Source: Bosch US Owner Support - Cooktops & Rangetops Error Codes

Error code F1
Appliance Cooktop
Quick answer

One cooking zone got too hot and switched itself off to protect the work surface. Let it cool, then switch it back on.

F1 needs a technician on site

F1 points to cooking zone overheated — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

When a Bosch induction cooktop shows F1, a single cooking zone has overheated and switched itself off. Bosch says the shutdown is there to protect the work surface, which is the cooking surface your pans sit on. The same entry on Bosch’s list also covers F6.

At a glance

Code F1
Appliance Cooktop
What it means A cooking zone has overheated and switched off to protect the work surface.

F1 and F6 mean the same thing

Bosch lists the two numbers together under one meaning and one fix. If your display reads F6, everything below applies to you as well.

Restarting the zone

  1. Leave the zone off until the electronics have had enough time to cool. Bosch does not give a fixed number of minutes.
  2. Switch that cooking zone back on. Bosch says you can then carry on cooking.

While you wait, slide the pan to a zone that is still working, or onto a trivet. The area around the zone stays hot after the shutdown and can burn a hand.

What the code does and does not tell you

Bosch does not list what drove the zone too hot, so we will not guess at it here. What F1 does confirm is that the zone switched itself off to protect the work surface. The other zones are not named in Bosch’s entry.

When a cooled zone still will not run

Bosch gives no call-service step for F1 on its induction list. Still, the owner fix has limits. If the zone refuses to restart after a full cool-down, or F1 shows on a cooktop that has not been used, the fix above no longer fits. Have it looked at.

Nearby codes

  • F2: the electronics overheated rather than the zone
  • F5: hot cookware sitting near the control panel
  • F1 on a Bosch range: the same message on induction slide-in ranges

San Francisco Bosch cooktop repair

If a zone keeps dropping out with F1, call (415) 851-9513. Tell us which zone it is and whether it restarts after cooling.

Plain language

What this code means

A cooking zone has overheated and switched off to protect the work surface.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair