Skip to content
Error Code

Bosch Cooktop F5 Error Code

Source: Bosch US Owner Support - Cooktops & Rangetops Error Codes

Error code F5
Appliance Cooktop
Quick answer

Hot cookware is too close to the control panel. With a flashing level it is a warning; with a tone alone, the zone has shut off.

F5 is the rare cooktop code whose cause you can usually see from where you stand: there is hot cookware near the control panel. Bosch splits it into two situations, and the display and the tone tell you which one you are in.

At a glance

Code F5
Appliance Cooktop
What it means Hot cookware near the control panel is putting the electronics at risk of overheating or has caused a zone to switch off.

Warning stage or shutdown stage

What you see and hear What Bosch says is happening What to do
F5, the power level flashing in turn with it, and a signal tone The electronics are at risk of overheating Move the cookware off the control panel and keep cooking
F5 and a signal tone, no flashing level The cooking zone has already switched off to protect the electronics Follow the four steps below

On the electric cooktop list, Bosch words the first case as F5 with the heat level and a tone. It is the same warning.

Why a pan near the panel matters

The touch controls share the cooktop surface with the cooking zones. According to Bosch, a hot pan resting on or beside the control area puts the electronics that run the panel at risk. The cooktop reacts in two stages: first a warning, then shutting the zone off.

After the zone has switched off

  1. Lift the cookware away from the control panel.
  2. Give it a few seconds.
  3. Touch any control on the cooktop.
  4. Once F5 has cleared and the electronics have cooled enough, set the zone again.

F5 and the automatic ignition

Bosch’s cooktop page also lists F2, F4 or F5 for when the automatic ignition is not working. There the cause is simply overheated electronics. Bosch’s fix is to switch all burners off or keep them on the minimum setting until the electronic system has cooled.

Keeping F5 away

  • Use the zones farthest from the controls for large pans that overhang their ring.
  • Rest hot lids, spoons and pans on a trivet, not on the control strip.
  • Wipe spills off the panel. Bosch notes elsewhere on the page that a wet or covered panel makes all indicators flash.

F5 questions

Is F5 a sign the cooktop is broken? Not by Bosch’s description. Both versions point to where the cookware is, and both clear once it is moved.

What if F5 shows with nothing near the panel? That falls outside what Bosch describes for this code. Note it and have the cooktop checked.

Related codes

  • F2: electronics overheated, one zone off
  • F4: electronics overheated, all zones off on electric models
  • F5 on a Bosch range: the induction slide-in range listing

Cooktop service for Bosch owners in San Francisco

An F5 that appears with a clear control panel is worth a call to (415) 851-9513. Tell us whether you hear the tone alone or see the flashing power level too.

Plain language

What this code means

Hot cookware near the control panel is putting the electronics at risk of overheating or has caused a zone to switch off.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair