Source: Bosch US Owner Support - Cooktops & Rangetops Error Codes
The cooktop cannot reach your home network or the paired hood. A restart clears a one-off fault; a repeat needs service.
E7010 on a Bosch cooktop is about connectivity, not heat. Bosch lists it in the induction section of its cooktop error page, and the meaning is short: the cooktop is unable to connect to your home network or to the hood.
At a glance
| Code | E7010 |
|---|---|
| Appliance | Cooktop |
| What it means | The cooktop is unable to connect to the home network or to the hood. |
Two links, one code
That wording tells you the cooktop keeps two separate connections. One goes to your home network, the other to the ventilation hood above it. E7010 covers a failure on either side. Bosch’s entry says nothing about the cooking zones, so the code itself is about the link.
Clearing E7010
Bosch gives a single action: switch the appliance off and on again. Then watch the display.
- The message is gone and stays gone. Bosch calls this a one-off occurrence. Nothing else is needed.
- The message comes back. Bosch’s next step is to book a technician and give the exact error code.
Things to note before you call
A few plain observations make the service conversation shorter. Is your home network working for phones and laptops? Is the hood powered and answering its own buttons? Did E7010 first appear after a power outage or after you replaced the router? None of these is a repair, and you do not need tools for any of them. Do not open the cooktop or the hood to look for loose wires, since both run on household current.
Codes that sound similar
- E9011: “not connected correctly” there refers to the electrical hookup, not to the network.
- dE: another message that is not a heating fault. It means demo mode is switched on.
Bosch cooktop service in San Francisco
If E7010 returns after a restart, call (415) 851-9513. Mention the code and that you have already switched the cooktop off and on.