Source: Bosch US Owner Support - Slide-In Ranges Error Codes
A cooking zone on the range top overheated and shut itself off to protect the surface. Let it cool and switch the zone on again.
On a Bosch induction slide-in range, F1 is a cooktop code, not an oven code. One cooking zone on the range top has overheated, and the range has switched that zone off to protect the work surface. Bosch’s slide-in range page lists F6 in the same entry.
At a glance
| Code | F1 |
|---|---|
| Appliance | Range |
| What it means | A cooking zone has overheated and switched off to protect the work surface. |
Is F6 different?
No. Bosch gives F1 and F6 a single shared meaning and a single fix, so either number leads you to the steps here.
What to do while the zone is off
The range does the protective part on its own. Your job is to wait until the electronics have cooled sufficiently, then switch the cooking zone back on, and Bosch says cooking can continue from there. The oven below is not part of this message, and Bosch gives no breaker reset for it.
The glass around a zone that just shut down stays hot. Move the pan to a trivet or another zone instead of leaving it to sit, and keep hands off the area until it has cooled.
Signs F1 needs a closer look
- The zone will not switch back on after a long cool-down.
- F1 or F6 shows on a range top that has not been used.
- The same zone drops out with F1 nearly every time it is used.
Bosch’s slide-in page does not list a service step for F1, but each of these goes beyond the cool-down fix it describes.
Other range-top codes
- F2: electronics overheated and a zone switched off
- F5: hot cookware sitting near the control panel
- F1 on a Bosch cooktop: the built-in cooktop listing
Induction range repair in San Francisco
If one zone keeps shutting down with F1, call (415) 851-9513. Say which zone and whether it comes back after cooling.