Source: Bosch US Owner Support - Dishwasher Error Codes
Bosch calls this a technical issue. A full power reset of at least two minutes comes first; a repeat means service.
Four LEDs flashing on their own point to a drain problem. Add beeping and Bosch reads it differently: there is a technical issue with the appliance. Bosch does not name a part for this signal. Instead it gives a set sequence for restarting the dishwasher, and a second sequence for shutting it down safely if the fault returns.
At a glance
| Code | 4 LEDs Flashing along with Beeping |
|---|---|
| Appliance | Dishwasher |
| What it means | Bosch describes four flashing LEDs with beeping as a technical issue that calls for a power reset and, if it recurs, a technician. |
Bosch’s restart sequence
- Press the ON/OFF button.
- Pull the power cord plug from the outlet, or switch off the breaker that feeds the dishwasher.
- Wait at least 2 minutes.
- Plug the cord back in, or switch the breaker back on.
- Switch the dishwasher on.
The wait is part of the instruction. Bosch specifies at least two minutes without power, so do not cut it short with a quick off-and-on.
If the plug is out of reach or the dishwasher is wired in directly, use the breaker instead. Breaker panels are not always labeled clearly, so check that the dishwasher has actually gone dark before you start counting.
If the lights and beeping come back
A repeat after the restart tells you the reset did not solve it. Bosch’s instructions for that case are:
- Press ON/OFF.
- Turn off the water faucet that supplies the dishwasher.
- Pull out the power cord plug.
- Book a technician.
Shutting off the water is a sensible precaution when the machine has reported a fault it cannot clear. It keeps the dishwasher from taking in more water while it waits for service. The supply valve is usually under the kitchen sink.
Beeping versus silent: why the difference matters
The two patterns look alike at a glance, and it is easy to start cleaning the drain pump when the dishwasher is actually beeping. The silent four-LED pattern has its own drain checklist. The beeping pattern does not; Bosch’s only owner action for it is the restart.
Signals that are easy to confuse with this one
- 4 LEDs flashing (no beeping): drain pump, hose or airgap.
- E0110: another Bosch electronics fault that goes straight to a technician.
- E27 / E9001: supply voltage too low, which also starts with a breaker reset.
Bosch dishwasher service for San Francisco homes
If the beeping returned after the two-minute restart, leave the water off and call (415) 851-9513. Let us know how many times you reset it and when the signal came back.