Skip to content
Error Code

Bosch Dishwasher E01 / E0100 Error Code

Source: Bosch US Owner Support - Dishwasher Error Codes

Error code E01 / E0100
Appliance Dishwasher
Quick answer

An electrical fault between the main control board and the heat pump motor. One breaker reset, then service.

E01 / E0100 needs a technician on site

E01 / E0100 points to e01 directs attention to the heat-pump motor control circuit on supported bosch dishwashers — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

When a Bosch dishwasher stops with E01 or E0100, the main control board has found a fault in the circuit that runs the heat pump motor. Bosch gives both numbers the same description on its owner-support page, so they are one fault shown in two formats.

At a glance

Code E01 / E0100
Appliance Dishwasher
What it means There is a heat pump motor circuit fault at the main control board.

Three terms in that description

Heat pump. In a Bosch dishwasher this is the pump that pushes wash water through the spray arms, with the water heater built into the same unit. It has nothing to do with the heat pumps used to heat homes.

Motor circuit. The wiring and switching that deliver power from the control to the pump’s motor.

Main control board. The electronic board that runs the cycle and switches each part on and off. Bosch places the fault at the board end of the circuit.

Put together, the code says the board could not drive the circulation motor the way it expected. It does not say whether the board, the wiring or the motor is at fault. That takes testing with meters.

The owner step

Bosch suggests one thing: cut power to the dishwasher at the breaker, leave it off for 30 seconds, and switch it back on. Then start a cycle and see whether the code returns. If you are unsure which breaker feeds the dishwasher, confirm the panel goes dark before you start timing.

If E01 comes back

A second appearance after the reset means it is time for service. Bosch’s page directs you to a technician. Don’t remove the toe kick or inner panels to look for the motor; the circuit runs on household current.

Codes tied to the same pump

Heat pump repair on Bosch dishwashers in San Francisco

Call (415) 851-9513 if E01 survives the breaker reset. Tell us whether it shows right at start or partway through a cycle.

Plain language

What this code means

There is a heat pump motor circuit fault at the main control board.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair