Source: Bosch US Owner Support - Dishwasher Error Codes
Six displays, one fault: the heater built into the heat pump. Bosch suggests a 30-second breaker reset before calling.
This is the Bosch dishwasher fault with the most names. E09, E20, E2030, E6001, flashing Active and Sanitized lights and flashing Clean and Sanitized lights all carry the same line on Bosch’s owner-support page: a heat pump internal heater fault.
At a glance
| Code | E09 / E20 / E2030 / E6001 / Flashing Active and Sanitized Lights / Flashing Clean and Sanitized Lights |
|---|---|
| Appliance | Dishwasher |
| What it means | There is a fault with the internal heater of the heat pump. |
Which display shows which signal
Bosch lists all six signals with the same description; which one you see depends on your model’s control panel.
The heater inside the heat pump
In a Bosch dishwasher, the heat pump is the circulation pump that moves wash water through the spray arms, with a heater built into it. The “internal heater” in this code is the heating part of it. When the control detects a problem with that heater, it reports the code.
What to do
Shut off the breaker that serves the dishwasher, give it 30 seconds, and power it up again. Start a program that heats, such as a normal wash, and see whether the code reappears. Bosch’s support page says to have a technician check it if the reset does not resolve it.
Avoid opening the dishwasher to look at the pump. The heater runs on mains current, and the pump around it is full of water connections.
See also
- E12 / E2060: limescale in the heat pump, which owners can descale.
- E21 / E6002: the heat pump is blocked.
- E01 / E0100: motor circuit of the same heat pump.
Bosch heating repairs in San Francisco
If the reset didn’t help, call (415) 851-9513. Tell us exactly which lights or numbers you see.