Skip to content
Error Code

Bosch Dishwasher E18 / E200 Error Code

Source: Bosch US Owner Support - Dishwasher Error Codes

Error code E18 / E200
Appliance Dishwasher
Quick answer

The tub is not filling to the level the control expects. Bosch's two checks are the inlet hose and the water supply.

A Bosch dishwasher showing E18 or E200 has noticed that not enough water reached the tub. Bosch’s support page puts it two ways: the water level is too low, or water is not being pumped correctly into the machine. Both numbers carry the identical description and the same two checks.

At a glance

Code E18 / E200
Appliance Dishwasher
What it means There is an issue with water flow into the dishwasher: the water level is too low, or water is not being pumped in correctly.

Check 1: the inlet hose

The inlet hose brings water from the supply valve to the dishwasher. Bosch asks you to make sure it isn’t kinked or damaged. You can usually see the start of it under the sink. A hose that has been crushed behind the machine, or one with a visible split, can starve the fill.

Damage is a reason to stop rather than to work around it. A split supply hose under pressure can leak into the cabinet, so turn the valve off and arrange a replacement.

Check 2: the water supply

Make sure the supply is actually turned on. Bosch adds a number here: the water flow rate should be 10 liters per minute, a bit over 2.5 gallons. The valve feeding the dishwasher should be opened all the way, not just cracked open.

Reading the situation

What you see What it suggests
Valve under the sink was closed or half open Open fully and run a cycle.
Hose kinked but intact Straighten it and restart.
Hose cracked, bulging or wet Turn water off; the hose needs replacing.
Supply and hose look fine, code returns Book a technician.

Bosch’s own guidance ends at those two checks and then refers you to a technician. It does not list an internal part for E18, so anything past the hose is diagnosis work.

FAQ

Related fill codes

Fill problems? Bosch dishwasher service in San Francisco

Call (415) 851-9513 once the valve and hose are ruled out. Mention the code and whether the hose looked damaged.

Plain language

What this code means

There is an issue with water flow into the dishwasher: the water level is too low, or water is not being pumped in correctly.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair