Source: Bosch US Owner Support - Dishwasher Error Codes
The supply voltage reaching the dishwasher is too low. Bosch points owners to an electrician, not an appliance repair.
Most Bosch dishwasher codes describe something wrong inside the machine. E27 and E9001 are different. Bosch’s support page says the house power supply to the unit is too low, and its printed manual, where the code appears as E:90-01 lighting up alternately, goes further: the mains voltage is too low, and this is not a fault on the appliance.
At a glance
| Code | E27 / E9001 |
|---|---|
| Appliance | Dishwasher |
| What it means | The house power supply to the dishwasher is too low. |
What “power supply too low” means
Every appliance is designed to run within a voltage range. The dishwasher monitors the voltage arriving at it, and when that drops below what it needs, it stops and reports E27. The cause is upstream of the dishwasher: the circuit, the outlet or connection it is fed from, or the supply to the building.
Step one: reset at the breaker
Bosch’s first instruction is a power reset. Turn the dishwasher’s breaker off for 30 seconds and back on, then try a cycle. A short dip in supply may not repeat.
Step two: an electrician, if it recurs
If the error occurs again, Bosch says to contact an electrician to check the incoming voltage to the appliance. The manual asks for both the mains voltage and the electrical installation to be checked. Measuring live voltage at an outlet or junction box is electrical work and should be left to a qualified electrician.
Things that are useful to tell the electrician:
- When the code shows up, for example only when other large appliances are running.
- Whether lights dim in the kitchen at the same time.
- Whether any other appliance on the same circuit misbehaves.
Why a dishwasher technician may not be the first call
Because Bosch states that this code does not indicate an appliance fault, a dishwasher repair visit will not fix a low supply. If the electrician confirms the voltage is correct and E27 keeps appearing, that is the point to have the dishwasher looked at.
Other codes that begin with a power reset
- 4 LEDs flashing with beeping: a technical issue that also starts with a power reset.
When E27 persists: Bosch service in San Francisco
If your electrician has confirmed the supply and E27 or E9001 keeps returning, call (415) 851-9513. Share what the electrician measured.