Skip to content
Error Code

Bosch Dishwasher E02 / E03 / E0103 / E0107 / Flashing Sanitized Lights Error Code

Source: Bosch US Owner Support - Dishwasher Error Codes

Error code E02 / E03 / E0103 / E0107 / Flashing Sanitized Lights
Appliance Dishwasher
Quick answer

Five ways a Bosch dishwasher reports the same relay fault on its main control board. One breaker reset, then service.

E02 / E03 / E0103 / E0107 / Flashing Sanitized Lights needs a technician on site

E02 / E03 / E0103 / E0107 / Flashing Sanitized Lights points to bosch dishwasher e02 is a control-electronics warning associated with a relay fault — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

Bosch uses five different signals for one fault on the main control board: a relay fault. You may see E02, E03, E0103, E0107, or flashing Sanitized lights, depending on the model.

At a glance

Code E02 / E03 / E0103 / E0107 / Flashing Sanitized Lights
Appliance Dishwasher
What it means There is a relay fault on the dishwasher's main control board.

The owner-support page repeats the same sentence for all five, so the advice below applies whichever one you have.

Relays in plain terms

A relay is a switch operated by electricity. The low-voltage logic on the control board cannot power a pump or heater directly, so it closes a relay, and the relay connects mains power to that part. A board carries several of them. When one sticks, fails to close, or does not respond as the control expects, the dishwasher reports a relay fault and stops.

Relays live on the board itself. They are not something an owner can see, test or replace.

Bosch’s suggested reset

  • Turn the dishwasher’s breaker off.
  • Count 30 seconds.
  • Turn it back on and try a cycle.

If the code or the flashing lights return, Bosch’s next step is a technician.

Signs to stop immediately

Any burning smell, buzzing from behind the kick plate, or a tripped breaker alongside the code means the dishwasher should stay off. Leave the breaker off and wait for a technician rather than resetting again.

Related control-board codes

  • E01 / E0100: heat pump motor circuit fault at the same board.
  • E05 / E0106: wash arm diverter circuit in the main control board.
  • E0110: electronics miscommunication.

Control board repair for Bosch in San Francisco

Call (415) 851-9513 and tell us which of the five signals you saw and whether the reset helped.

Plain language

What this code means

There is a relay fault on the dishwasher's main control board.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair