Skip to content
Error Code

Bosch Dishwasher E05 / E0106 Error Code

Source: Bosch US Owner Support - Dishwasher Error Codes

Error code E05 / E0106
Appliance Dishwasher
Quick answer

The circuit that drives the wash arm diverter has failed at the main control board. Reset once at the breaker, then call.

E05 / E0106 needs a technician on site

E05 / E0106 points to e05 focuses diagnosis on the wash-arm diverter control circuit — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

E05 (or E0106) tells you the main control board has a problem with the circuit for the wash arm diverter. Bosch lists the two numbers with identical text on its owner-support page.

At a glance

Code E05 / E0106
Appliance Dishwasher
What it means There is a fault in the wash arm diverter circuit in the main control board.

What the diverter is for

A dishwasher has more than one spray arm, typically one under the lower rack and one or more higher up. Rather than spray through all of them at full pressure at once, the machine uses a diverter to send water to one arm or level, then another. The main control board decides when the diverter switches.

E05 points at that switching circuit on the board. Bosch’s wording places the fault “in main control board,” not in the spray arms, so cleaning the arms is not a fix for this code.

Try this once

Bosch’s suggestion is a power reset. Go to the electrical panel, flip off the breaker that supplies the dishwasher, leave it off for half a minute, and flip it on again. Run a short program and watch whether E05 reappears.

A single clean cycle afterward does not prove the fault is gone for good. If it comes back on a later wash, treat that the same as an immediate return.

Next step if it returns

Book a technician. The board and the diverter motor are behind the dishwasher’s panels and connected to mains power, so neither is an owner repair.

Questions about E05

Similar board faults

Bosch diverter and board service, San Francisco

If E05 is back after a reset, call (415) 851-9513. Let us know whether it shows at the start of a cycle or later.

Plain language

What this code means

There is a fault in the wash arm diverter circuit in the main control board.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair