Skip to content
Error Code

Bosch Wall Oven E310 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E310
Appliance Oven
Quick answer

E310 is a data memory error in the oven's control module. Bosch's service manual lists the description without a cause or test.

E310 needs a technician on site

E310 points to data-memory fault in the control module — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

The error table in Bosch’s service manual for the 2007 300, 500 and 800 Series built-in wall ovens has a single line for E310: data memory error in the control module. There is no cause, check or diagram listed next to it.

At a glance

Code E310
Appliance Oven
What it means Data memory error in the control module.

Which memory, which board

The oven has two circuit boards that each keep data. The user interface, behind the control panel, reports its memory faults as E010. The control module, the relay board under the top access panel that switches the elements, fans, lights and latch, reports them as E310. So E310 concerns the board that does the switching, not the display.

A reset, then a call

Turn off the oven’s breaker, wait 30 seconds and switch it back on. Bosch uses this same power cut to reset the oven in its service procedures. If the display shows E310 again, there is nothing further for an owner to try. Reaching the control module means pulling a built-in oven partway out of the cabinet, which is technician work.

Repair notes from the manual

Bosch tells service techs to reseat each connector on the control module before replacing it, and to reset and test the oven after a new module goes in, sometimes twice.

A module swap can also involve configuration. When both boards are new, the manual expects the Option Code to be set in Service Mode, otherwise the oven reports E000.

Other board codes

  • E309: ROM check error on the same control module
  • E010: the user interface version of a memory error
  • E312: the temperature sensor on the control module has failed

Wall oven board repair, SF

For E310 that returns after a breaker reset, call (415) 851-9513. Mention any power outage or breaker trip just before the code first appeared.

Plain language

What this code means

Data memory error in the control module.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair