Skip to content
Error Code

Bosch Wall Oven E312 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E312
Appliance Oven
Quick answer

E312 points to a defective temperature sensor on the control module circuit board, not the sensor inside the oven cavity.

E312 needs a technician on site

E312 points to control-module temperature-sensor fault — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

Two different temperature sensors can confuse owners on a Bosch wall oven. One sits in the oven cavity and controls cooking. The other is a tiny sensor on a circuit board. E312 concerns the second kind: Bosch’s service manual for the 2007 300, 500 and 800 Series built-in wall ovens lists it as a defective control module PCB temperature sensor.

At a glance

Code E312
Appliance Oven
What it means The temperature sensor on the control module PCB is defective.

Where that sensor is

The control module, also called the relay board, sits in the top of the oven beneath an access panel. It switches power to the heating elements and other loads. Bosch lists a separate code, E303, for this board running above 212°F (100°C). E312 is about the board’s own temperature sensor being defective, as opposed to the board being hot.

What helps and what does not

  • Helps: a 30-second breaker reset, then checking whether E312 returns. Write down when it shows.
  • Does not help: cooling the oven, adjusting the temperature offset in the settings menu, or replacing the cavity sensor. None of those touch the sensor this code names.

The manual lists no test for E312. Because the sensor is part of the control module, a confirmed fault is a module repair. Bosch’s instructions for that job are to reseat all connectors first, and to reset and test the oven after the new module is installed.

Related board codes

  • E303: control module above 212°F
  • E012: the matching sensor fault on the user interface board
  • E310: data memory error on the same module

Service for E312 in San Francisco

Call (415) 851-9513 if E312 is still there after a breaker reset. The FD number on the data plate under the control panel shows when your oven was built.

Plain language

What this code means

The temperature sensor on the control module PCB is defective.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair