Skip to content
Error Code

Bosch Wall Oven E012 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E012
Appliance Oven
Quick answer

E012 points to a defective temperature sensor on the user interface circuit board. Bosch's service manual lists no owner action for it.

E012 needs a technician on site

E012 points to user-interface pcb temperature-sensor fault — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

E012 is listed in Bosch’s service manual for 2007 built-in wall ovens (300, 500 and 800 Series) as a defective user interface PCB temperature sensor. It does not refer to the sensor inside the oven cavity that controls baking. It refers to a small sensor on the control panel’s own circuit board.

At a glance

Code E012
Appliance Oven
What it means The temperature sensor on the user interface PCB is defective.

Why the control panel has a thermometer

The panel electronics sit just above a cavity that can run very hot, and a sensor on the board reports how warm the electronics themselves are. Bosch lists a separate code, E003, for the panel electronics passing 185°F (85°C). E012 is a different situation: the sensor itself is reported as defective. The manual offers no cause or test for this line, and there is nothing on it for an owner to adjust.

On 800 Series ovens this board sits behind the glass touch panel with its graphical display. On 500 and 300 Series models it sits behind the dials and keys.

Sensible next steps

Cutting power at the breaker for 30 seconds and restoring it is a harmless check, and it is the reset Bosch uses in its own procedures. If E012 is back afterward, the sensor is part of the user interface board, which Bosch services together with its chassis as one assembly. That makes it a parts-and-labor repair from the front of the oven, done by a technician who resets and tests the oven afterward.

Connected codes

  • E003: panel electronics over 185°F
  • E312: the same sensor failure on the control module board
  • E010: a different fault in the same interface board, its data memory

Help with E012 in San Francisco

Call (415) 851-9513 for Bosch wall oven service. It helps to read us the model number from the plate on the underside of the control panel.

Plain language

What this code means

The temperature sensor on the user interface PCB is defective.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair