Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table
E107 (upper or single oven) and E207 (lower oven) mean the door latch does not unlock. Bosch's manual gives a power-cycle step once the cavity has cooled.
A locked oven door after self-clean is normal for a while. A door that stays locked with E107 (upper or single oven) or E207 (lower oven of a double) on the display is not. These codes mean the door latch does not unlock, per Bosch’s service manual for its 2007 300, 500 and 800 Series built-in wall ovens.
At a glance
| Code | E107 / E207 |
|---|---|
| Appliance | Oven |
| What it means | The door latch does not unlock: E107 for cavity 1 (upper or single oven), E207 for cavity 2 (lower oven). |
Give it time first
The motorized latch locks when the oven is set to CLEAN and is designed to unlock only after the cavity cools to about 490°F. Right after a self-clean the cavity is still very hot. Never try to force the door: it is heavy, the glass and cavity are extremely hot, and the latch is a motor-driven assembly that is easy to damage. Wait until the oven has had time to cool down.
Bosch’s manual puts the door’s weight at about 38 pounds and warns against forcing it open or closed.
Bosch’s steps for a stuck latch
The service manual gives two simple steps, depending on how the latch is stuck:
| Situation | What the manual says to do |
|---|---|
| Latch stuck in the locked position | Turn the unit off and back on. This opens the latch if the cavity temperature is below 450°. |
| Latch stuck partly locked | Press SELF CLEAN, then ON/OFF. |
The first only works once the cavity is cool enough, which is another reason to be patient. If neither step releases the door, stop. Do not remove trim or screws around the latch.
What service involves
The latch, its motor and its two internal switches (door and lock/unlock) are replaced together. The assembly is reached from the front after a trim piece is removed. Before replacing it, a technician can operate the latch from Service Mode and check the motor circuit at the control module, since a latch that will not move and a control that never tells it to move can look the same from the outside.
Questions about E107
Can I use the oven while the door is locked?
No. With the latch closed you cannot load the oven, and the code says the control could not release it.
Is this the same as E126?
Not quite. E107 says the latch did not unlock when asked; E126 says the control cannot tell where the latch is. Both lead a technician to the same assembly.
Why did it happen after self-clean?
The latch locks when the oven is set to clean, so a latch that fails to release shows up when that cycle ends.
Related door codes
- E106 / E206: latch that will not lock when self-clean starts
- E126 / E226: a latch position the control cannot identify
- E115 / E215: cavity temperature too high while the door is unlocked
Locked-door service for SF wall ovens
If the door stays shut after the oven has cooled and Bosch’s steps did not release it, call (415) 851-9513. Tell us which steps you already tried and which cavity is locked.