Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table
E122 means the meat probe reading is too high or the probe circuit is shorted. Bosch's manual points to the probe receptacle and harness.
If you cook with the meat probe and the display shows E122, the oven is reading the probe as too hot or shorted. Bosch’s service manual for 2007 300, 500 and 800 Series built-in wall ovens gives a direct pointer for it: check the probe receptacle and harness.
At a glance
| Code | E122 |
|---|---|
| Appliance | Oven |
| What it means | The probe sensor temperature is too high, or the probe circuit is shorted; check the probe receptacle and harness. |
The probe circuit in three parts
| Part | Where it is | Who checks it |
|---|---|---|
| Probe and cable | Loose, plugs into the cavity wall | You can look it over |
| Probe receptacle | Socket in the oven cavity | Visual check by you; testing by a technician |
| Harness and probe module | Behind the cavity wall, running to the control module | Technician only |
The manual describes the standard probe module as part of the control module, and its plug table shows the probe connector as not used on HBL3 and HBN3 models.
What you can safely look at
- With the oven off and cool, pull the probe out of its socket.
- Look for a cable that is pinched, melted or stiff in one spot, and for a bent or discolored plug.
- Shine a flashlight into the receptacle and note anything that looks damaged or out of place. Do not poke metal objects into it.
- Power the oven back up and see whether E122 appears without the probe in place.
Calling it in
If the code shows with a probe that looks fine, or with the probe removed, the receptacle and the harness behind it need to be tested, which means access behind the cavity and work near the control module. That is service work.
Other codes on this circuit
- E123: the opposite reading, probe temperature too low
- E116: general probe error tied to the control module
Probe circuit service in San Francisco
Call (415) 851-9513 if E122 stays after you have checked the probe and its socket. Say whether the code appears with nothing plugged in.