Skip to content
Error Code

Bosch Wall Oven E123 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E123
Appliance Oven
Quick answer

E123 means the meat probe sensor temperature reads too low. The service manual lists no cause or test beyond the description.

E123 needs a technician on site

E123 points to cavity 1 meat-probe sensor temperature too low — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

E123 appears in Bosch’s service manual for the 2007 300, 500 and 800 Series built-in wall ovens with a short description: probe sensor temperature too low. The manual stops there, with no cause or check listed, so this page covers what the probe system is and how to hand the problem over cleanly.

At a glance

Code E123
Appliance Oven
What it means The probe sensor temperature reads too low.

About the probe

The meat probe is a temperature sensor on a cable. You push it into the food and plug it into a socket inside the oven, and the oven reads the food’s internal temperature through it. The reading travels through a harness to the PC control module, which contains the standard probe module according to the manual. The same manual marks the probe connector on that board as not used on HBL3 and HBN3 models.

What is reasonable to try

With the oven off and cool, unplug the probe and check that the plug and cable are intact. Plug it back in firmly so it seats fully. Reset the oven at the breaker for 30 seconds and try again. If E123 comes straight back, stop using the probe function and arrange service. The socket wiring and the control module are behind the cavity and top panels, which is technician territory.

When you book, say whether the code came up with the probe in food, with the probe plugged in and empty, or with nothing plugged in at all. That detail helps the technician decide where to start.

Neighbors of E123

  • E122: the high side of the same reading, too hot or shorted
  • E116: general probe error
  • E104 / E204: a different sensor, the one that measures cavity air temperature

Arranging E123 service in SF

Call (415) 851-9513 for Bosch oven service in San Francisco. Mention whether a breaker reset changed anything.

Plain language

What this code means

The probe sensor temperature reads too low.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair