Skip to content
Error Code

Bosch Wall Oven E303 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E303
Appliance Oven
Quick answer

E303 means the oven's control module, the relay board in the top of the unit, exceeded 212°F / 100°C.

E303 needs a technician on site

E303 points to electronics temperature difference too high — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

E303 is one of two “electronics too hot” codes in Bosch’s service manual for the 2007 300, 500 and 800 Series built-in wall ovens. This one concerns the control module, and the limit is 212°F (100°C). When the board gets hotter than that, the display shows E303.

At a glance

Code E303
Appliance Oven
What it means The control module electronics exceeded 212°F (100°C).
First thing to try Turn the oven off. Keep the door closed so the heat stays inside the cavity instead of rolling up over the panel.

What the control module is

Bosch calls it the PC control module or relay board. It is the board that actually switches power to the bake, broil and convection elements, the convection and cooling fans, the lights and the motorized door latch. It sits in the top of the oven under an access panel, reached by sliding the unit about 15 to 16 inches out of the wall. The control panel you touch is a separate board; its own overheat code is E003, with a lower limit of 185°F (85°C).

What to do when E303 appears

  1. Turn the oven off. Keep the door closed so the heat stays inside the cavity instead of rolling up over the panel.
  2. Listen for the cooling fan. Bosch says these fans run for two minutes after shut-off and then keep going until the cavity has cooled further, so let the oven sit.
  3. Once it is cool, use it again normally and see if the code comes back.

The manual lists the limit only, without causes. If E303 recurs, book service rather than repeatedly letting the board overheat.

For comparison

Code Board Limit
E003 User interface (control panel) 185°F / 85°C
E303 Control module (relay board) 212°F / 100°C

Read next

  • E118 / E218: cooling fan speed out of range
  • E312: the temperature sensor on this board is defective
  • E003: the panel-side version of this warning

Bosch control board service in San Francisco

If E303 keeps returning, call (415) 851-9513. Let us know how long the oven had been running and in which mode.

Plain language

What this code means

The control module electronics exceeded 212°F (100°C).

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair