Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table
E003 means the oven's user interface electronics exceeded 185°F / 85°C. The service manual lists the limit but no owner fix.
On Bosch 300, 500 and 800 Series built-in wall ovens, E003 reads “electronics too hot.” The service manual pins it to one part: the user interface has gone above 185°F (85°C).
At a glance
| Code | E003 |
|---|---|
| Appliance | Oven |
| What it means | The user interface electronics exceeded 185°F (85°C). |
The part that overheated
The user interface is the control panel assembly above the door. On 800 Series ovens it is a glass touch panel with a graphical display; on 500 and 300 Series models it carries the dials and keys. Behind the panel sits a circuit board, and that board watches its own temperature. E003 is the board telling you it crossed its limit. Bosch’s manual lists only the threshold, without causes or owner steps.
What you can do safely
- Switch the oven off and leave the door closed.
- Let the cooling fan run. Bosch notes that these ovens keep the cooling fans going for two minutes after shut-off and then until the cavity cools further, so a fan sound after switching off is normal.
- Write down what the oven was doing when E003 appeared, for example a long bake, broil or self-clean, and whether one or both cavities were on.
If the code returns on the next use, stop using the oven and book service. Repeated overheating of control electronics is not something to keep resetting.
Similar heat and sensor codes
- E303: the same kind of warning, but for the control module in the top plenum (limit 212°F / 100°C)
- E012: the temperature sensor on the interface board itself is defective
- E118 / E218: cooling fan running too slow or too fast
Getting an overheating panel repaired in San Francisco
Call (415) 851-9513 with the code and what the oven was doing at the time. The model and FD numbers are printed on the data plate on the underside of the control panel.