Skip to content
Error Code

Bosch Wall Oven E010 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E010
Appliance Oven
Quick answer

E010 is a data memory error in the oven's user interface, the control panel electronics. The service manual gives no owner steps for it.

E010 needs a technician on site

E010 points to data-memory fault in the user interface — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

E010 on a Bosch 300, 500 or 800 Series built-in wall oven means a data memory error in the user interface. Bosch’s service manual lists the description and nothing else: no cause, no test.

At a glance

Code E010
Appliance Oven
What it means Data memory error in the user interface.

What the user interface holds

The user interface is the control panel above the door, with its display and keys or dials. Behind it is a circuit board mounted on a metal chassis. Besides showing the display, that board stores data it needs to run, and E010 says the board found a problem with that stored data. It is an electronics fault on the panel side, separate from the relay board that switches the heating elements.

Before you call

  1. Turn the oven off at the circuit breaker for 30 seconds, then back on. Bosch’s own reset step works the same way.
  2. Set the clock if the oven asks for it.
  3. If E010 comes back, stop there. There is nothing behind the panel for an owner to adjust.

How the repair is handled

According to the manual, the interface board and its chassis are serviced as a single assembly, and after a new one is installed the oven must be reset and tested. The panel is removed from the front once the oven has been slid about 4 inches out of the wall.

Memory and board codes nearby

  • E310: the same kind of memory error, in the control module instead
  • E009: ROM check failure in this same panel
  • E012: a failed temperature sensor on the interface board

Control panel repair for Bosch ovens in SF

For E010 that survives a breaker reset, call (415) 851-9513. Have the model number from the data plate under the control panel ready.

Plain language

What this code means

Data memory error in the user interface.

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair