Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table
E115 (upper or single oven) and E215 (lower oven) mean the cavity temperature is too high while the door is unlocked. Bosch's manual gives no owner fix.
E115 and E215 tell you a Bosch built-in wall oven found its cavity too hot while the door was unlocked. E115 refers to cavity 1, the upper or only oven; E215 refers to cavity 2, the lower oven of a double. The codes come from Bosch’s service manual for the 2007 300, 500 and 800 Series wall ovens, which lists the description and no cause or test.
At a glance
| Code | E115 / E215 |
|---|---|
| Appliance | Oven |
| What it means | The cavity temperature is too high while the door is unlocked: E115 for cavity 1 (upper or single oven), E215 for cavity 2 (lower oven). |
Why “unlocked” is part of the code
These ovens have a motorized door latch. The manual describes it locking for self-clean and unlocking only once the cavity has cooled to about 490°F. The control knows both things at once, the latch position and the cavity temperature, and E115 or E215 is the combination it does not accept: high heat with the latch open. The manual does not say which part is to blame, so a technician has to find out whether the reading, the latch or the heating is at fault.
Right now
- Turn the oven off and keep the door closed. Opening a very hot oven releases a blast of heat at face level on a wall unit.
- Keep people and pets away from the door while it cools.
- If you are ever unsure whether the oven is still heating, switch it off at the breaker.
- Once it is cool, do not run self-clean or a high-heat mode until it has been checked.
For the technician
The manual gives no test for this code; the likely inputs are the cavity sensor and the latch switches, both wired to the control module. The manual’s own procedures check that sensor with an ohmmeter and let the latch be run from Service Mode, so those are the tools a technician brings to it.
Linked codes
- E101 / E201: open cavity temperature sensor
- E126 / E226: door latch in an undefined state
- E107 / E207: latch that will not unlock after a clean cycle
Overheating oven repair, San Francisco
Call (415) 851-9513 once the oven is off and cooling. Tell us which cavity showed the code and what mode was running.