Skip to content
Error Code

Bosch Wall Oven E106 / E206 Error Code

Source: Service Manual for 300, 500 and 800 Series Built-in Wall Ovens (Bosch HBL8x50UC, HBL57x0UC, HBL56x0UC, HBL54x0UC, HBL35x0UC, HBL33x0UC, HBN56x0UC, HBN54x0UC, HBN35x0UC, HBN34x0UC, HBN3350UC), section 5.1 Error Code Table

Error code E106 / E206
Appliance Oven
Quick answer

E106 (upper or single oven) and E206 (lower oven) mean the motorized door latch does not lock. Self-clean cannot run until it is fixed.

E106 / E206 needs a technician on site

E106 / E206 points to cavity 1 door latch does not lock — an internal part that can’t be checked or fixed safely from the outside. A restart may hide it for a while, but the cause stays. Our technician tests it on site and confirms the fault before any part is replaced.

Self-clean on a Bosch wall oven only runs with the door locked. On the 2007 300, 500 and 800 Series built-in models, a small motor drives the lock. If the oven asks for the lock and the latch never reports locked, the display shows E106 for the upper or single cavity, or E206 for the lower cavity of a double oven.

At a glance

Code E106 / E206
Appliance Oven
What it means The motorized door latch does not lock: E106 for cavity 1 (upper or single oven), E206 for cavity 2 (lower oven).

How the latch is supposed to work

Bosch’s service manual calls the part the motorized door latch (MDL), a 120-volt, 5-watt mechanism with two switches inside it: a door switch that reports whether the door is closed, and a lock/unlock switch that reports the latch position. In normal use:

  1. You set the mode and temperature selectors to CLEAN.
  2. The latch motor drives the lock closed automatically.
  3. Self-clean runs.
  4. When the oven has cooled to about 490°F, the latch unlocks.

E106 and E206 mean step 2 did not happen.

What you will notice

The manual’s troubleshooting table describes a failed latch motor this way: the oven accepts every mode except self-clean. When set to self-clean, the display stays on, the door does not lock, self-clean does not start, and E106 (or E206) appears. In other words, regular baking and broiling can still be available while the clean cycle is not.

Owner checks

  • Make sure the door is fully closed before choosing CLEAN, and that nothing such as a rack or foil is keeping it from seating.
  • Do not push, pull or pry at the latch area to help it along.
  • Try a breaker reset: power off for 30 seconds, then back on.

If self-clean still fails with the same code, skip the clean cycle and book service. Normal cooking is a judgment call; if anything about the door or latch feels loose or the code shows outside of self-clean, stop using that oven.

The repair

The latch and motor are serviced as one assembly from the front of the oven, behind a trim piece that has to come off first. A technician can run the latch in Service Mode to see whether it moves, and checks the motor circuit and the switch wiring back at the control module before replacing it.

E106 and E206 questions

Does E206 affect the upper oven?
No. Each cavity of a double oven has its own latch motor, and the manual’s test table lists the lower one separately: when it fails, the lower oven refuses self-clean and shows E206.

Should I keep retrying self-clean?
No. Each attempt asks a latch that already failed to move again. One confirmed failure is enough to book the repair.

Other latch and door codes

  • E107 / E207: the reverse problem, a latch that will not unlock
  • E126 / E226: the latch position cannot be determined
  • E124 / E224: the door switch inside the same assembly is in an undefined state

Door lock repair for Bosch ovens in San Francisco

Call (415) 851-9513 and let us know whether the code shows only when you start self-clean. Note whether it is the upper or lower oven.

Plain language

What this code means

The motorized door latch does not lock: E106 for cavity 1 (upper or single oven), E206 for cavity 2 (lower oven).

Ready to get your Bosch appliance working again?

Book a repair online or call us — clear estimates and approval before any repair work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area San Francisco Bay Area, California

Request your repair

(415) 851-9513 Book a Repair