Source: Bosch US Owner Support - Freestanding Ranges Error Codes
Bosch describes E100 only as an electronics fault. Reset the range at the breaker; if it returns, book service.
E100 is one of the broadest codes on Bosch’s freestanding range list. The description is just “an electronics fault has occurred.” Unlike most entries on that list, Bosch prints it with a capital E. It applies to both the electric and the gas freestanding models.
At a glance
| Code | E100 |
|---|---|
| Appliance | Range |
| What it means | An electronics fault has occurred. |
| When to call a technician | Reset the range at the breaker; if it returns, book service. |
Why the description is so short
Bosch does not tie E100 to a single part and lists no cause for it. The entry gives one reset and then a service step. That is the whole of what Bosch publishes for this code.
The one owner step
Turn the range off at its circuit breaker and leave it off for five minutes. Then switch the breaker back on. A fault that clears after this and does not return needs nothing more.
Signs it is time to book service
- E100 is back right after the breaker reset.
- It returns every few days, even if the range works in between.
- Other codes start appearing along with it.
In each case Bosch’s direction is to book a visit. Leave the back panel and the electrical connection alone.
Notes worth keeping
Because Bosch’s description is so general, details from your side carry weight. Write down when E100 appeared: at power-up, while the oven was heating, or while the cooktop was in use. Note whether the breaker reset cleared it for hours, days or not at all.
Neighboring electronics codes
- e005: the user interface and power board lost communication
- e310: a power supply failure, where house voltage is checked
Freestanding range repair, San Francisco
For an E100 that keeps coming back, call (415) 851-9513. Write down any other codes that appear with it.