Source: Bosch US Owner Support - Freestanding Ranges Error Codes
The range has detected a power supply failure. Bosch's steps are a voltage check of the house wiring and a five-minute breaker reset.
e310 is Bosch’s freestanding range code for a power supply failure. The problem is with the electricity reaching the range, and Bosch’s first step is outside the appliance: have an electrician check the voltage at the range’s supply.
At a glance
| Code | E310 |
|---|---|
| Appliance | Range |
| What it means | There is a power supply failure. |
What Bosch asks you to do
- Voltage check of the house wiring. Confirm that the supply to the range is at the correct voltage.
- Breaker reset. Switch the range off at the circuit breaker, wait five minutes, and switch it back on.
- Service if it persists. Book a visit.
Who should do the measuring
Measuring the supply to a range means testing a live circuit, which is a job for an electrician. That is a job for an electrician or a technician with a meter, not for an owner with a borrowed tester. Before anyone arrives, you can safely note whether lights dim when the range turns on, whether the breaker has tripped, and whether other appliances on the same panel act up.
Gas or electric, same code
Bosch lists e310 identically for its electric and gas freestanding ranges. Bosch gives the same steps for gas and electric models.
After the reset
If e310 is gone once the breaker is back on and the voltage checks out, the range can be used. If it returns, the next step is service, as Bosch states.
Related power and wiring codes
- e101: a sensor code where Bosch also asks you to check the power cord wiring
- U400 / E9000 / E9010: supply voltage outside the normal range on slide-in ranges
- E100: a general electronics fault
Bosch range power fault service, San Francisco
If e310 returns even with correct voltage, call (415) 851-9513. Share what the electrician measured, if you have it.